Table of Contents
Advertisement
5.4
HOW TO MODIFY THE INFORMATION PRESENT IN THE MAIN SCREEN
5.4.1 Select Probes For Display
To select the probes to display on the keyboard, modify the parameters from DP01 to DP04 (see
Programming parameters paragraph).
5.5
SET KEY IN MAIN SCREEN
To set the set-point of the cooling and/or heating from the main screen, press SET. In this way, enter the set-
point screen.
Chiller mode:
Heat pump mode:
To modify the values, position the cursor on the element "Cooling" or "Heating" temperature and press the
SET key:
The element starts to flash.
Increase or decrease the value using the UP and DOWN keys.
Confirm the modification by pressing the SET key again.
The cursor will automatically position itself on the next element, to modify it repeat the operation just
described.
1592025050 iProChill v2.5 10D00 AG v1.3 GB 18.02.2016.docx
iProCHILL
23/205
Advertisement
Table of Contents
