Inserting And Removing Devices; Inserting The I/O Module; Figure 7: Insert I/O Module (Example) - WAGO I/O-SYSTEM 750 XTR Manual

WAGO-I/O-SYSTEM 750 XTR
750-407/040-000 2DI 220V DC 3.0ms /XTR
Pos : 54.7 /Serie 750 (WAGO-I/O-SYST EM)/M ontieren/D emontieren/Geräte einfüg en und entfer nen - Ü berschrift 2 @ 3\mod_1231768483250_21.doc x @ 25950 @ 2 @ 1
5.2

Inserting and Removing Devices

Pos : 54.8 /All e Seri en ( Allgemei ne Module)/Sicherheits- und s ons tige Hi nweis e/Vorsic ht/Vorsicht: H eiß e Oberfläc he allgemei n @ 6\mod_1264428115588_21.doc x @ 48610 @ @ 1
Hot surface!
The surface of the housing can become hot during operation. If the device was
operated at high ambient temperatures, allow it to cool off before touching it.
Pos : 54.9 /All e Seri en ( Allgemei ne Module)/Sicherheits- und s ons tige Hi nweis e/Ac htung/Achtung: Arbeiten an Ger äten nur s pannungsfr ei durc hführ en! @ 6\mod_1256193963573_21.doc x @ 43426 @ @ 1
Perform work on devices only if they are de-energized!
Working on energized devices can damage them. Therefore, turn off the power
supply before working on the devices.
Pos : 54.10 /Serie 750 ( WAGO-I/O-SYST EM)/Wichtig e Erl äuter ung en/Sic her hei ts- und s onstige Hinweise/Ac htung/Ac htung: XTR nic ht unter -20 °C verdr ahten oder umstec ken @ 15\mod_1367559895186_21.doc x @ 118480 @ @ 1
Observe operating temperature!
XTR I/O modules may be operated below −20 °C, but not wired and/or
reconnected.
Pos : 54.11 /Serie 750 ( WAGO-I/O-SYST EM)/Monti eren/D emonti eren/Bus kl emme einfügen @ 3\mod_1231769726703_21.doc x @ 25989 @ 3 @ 1
5.2.1

Inserting the I/O Module

1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.

Figure 7: Insert I/O Module (Example)

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.
Manual
Version 1.2.0
Mounting 31