Starting Up The Ehernet Network; Figure 13: Completing The Setup - WAGO 750-880 Quickstart Reference

26 Quickstart Description
10. Complete the CoDeSys setup by clicking the button [Finish].

Figure 13: Completing the setup

3.2.2

Starting Up the Ehernet Network

This section provides you with a step-by-step sample procedure for starting up the
ETHERNET network.
You must perform three steps to start up the network:
• Determine the IP address of your PC and change it if required
• Assign an IP address to the SPS
• Test the ETHERNET link
The description of these work steps can be found in the corresponding following
sections.
Good example!
This description is just an example and only describes the procedure for local
startup of a single SPS using a non-networked computer under the Windows
system.
750-880, -881, -882 ETHERNET Programmable Fieldbus
WAGO-I/O-SYSTEM 750
Quickstart Reference
Version 1.0.0