Initial Setting - Mitsubishi Electric MELSEC Q Series User Manual

5 UTILITY PACKAGE (GX Configurator-DA)

5.4 Initial Setting

5 - 14
[Purpose]
Set the following items in the initial setting parameters.
• D/A conversion enable/disable setting
• Rate control enable/disable setting
• Increase/decrease digital limit values
• Disconnection detection setting
• Warning output setting
• Warning output upper limit value/lower limit value
Setting parameters in the Initial setting screen can omit parameter settings with
sequence program.
1 The disconnection detection mode and disconnection detection setting value
cannot be set by GX Configurator-DA.
Use sequence programs for the setting.
[Operating procedure]
2
"Start I/O No. "
Initial setting
2 Enter the start I/O No. in hexadecimal.
[Setting screen]
[Explanation of items]
(1) Setting contents
Set D/A conversion enable/disable setting, Rate control enable/disable setting
and others for each channel.
(2) Command button
Make text file
End setup
Cancel
1
"Module type" "Module model name"
Creates a file containing the screen data in text file format.
Saves the set data and ends the operation.
Cancels the setting and ends the operation.
MELSEC-Q
5 - 14