Mitsubishi Electric MELSEC Q Series User Manual page 118

6 PROGRAMMING
6 - 8
(2) Operating the utility package
(a) Initial setting (Refer to Section 5.4)
CH1, CH2 D/A conversion enable/disable setting .... "Enable"
CH1 Rate control enable/disable setting ................... "Enable"
CH1 Increase digital limit value ................................. "100"
CH1 Decrease digital limit value ................................ "30"
CH1 Disconnection detection setting......................... "Enable"
CH2 Warning output setting ....................................... "Enable"
CH2 Warning output upper limit value ....................... "10000"
CH2 Warning output lower limit value ....................... "3000"
(b) Auto refresh setting (Refer to Section 5.5)
CH1, CH2 Digital value .............................................. W11, W12
CH1, CH2 Output monitor value ................................ W113, W114
Disconnection detection ............................................. W115
Warning output ........................................................... W116
Error code ................................................................... W117
(c) Write of intelligent function module parameters (Refer to Section 5.3.3)
The intelligent function module parameters are written to the remote I/O
station.
Perform this operation on the parameter setting module selection screen.
MELSEC-Q
6 - 8