APPENDICES
Control data setting
Offset/gain value restoration
App - 9
(c)
When the offset/gain values are restored, the reference accuracy falls to
about less than three times of the accuracy before that.
POINT
D/A conversion is suspend if the G(P).OGSTOR instruction is executed.
To resume the D/A conversion, turn Operating condition setting request (Y9) from
off to on, then to off again.
(2)
Operation error
In any of the following cases, an error occurs and the corresponding error code is
stored into the completion status area (S)+1.
Error code
161
162
163
164
(3)
Program example
The following program is designed to read the offset/gain values of the Q62DA-
FG mounted in the position of I/O number X/Y0 to X/YF when M11 is turned on.
Case resulting in operation error
The G(P).OGSTOR instruction was executed in the offset/gain
setting mode.
The G(P).OGSTOR instruction was executed consecutively.
The G(P).OGSTOR instruction was executed for the model that
differs from the model for which the G(P).OGLOAD instruction had
been executed.
The value set to Pass data classification setting (S)+2 is outside the
range.
Performs processing at abnormal completion
MELSEC-Q
Dedicated instruction
(GP.OGSTOR)
App - 9