Mitsubishi Electric MELSEC Q Series User Manual page 79

4 SETUP AND PROCEDURES BEFORE OPERATION
4 - 15
POINT
When running this program together with the normal-mode D/A conversion program
(shown in Section 6.2.2), use *1 of this program as the initial setting program.
When using functions of the Q62DA-FG with the D/A conversion program in the
normal mode, add the respective initial setting items to the functions to be used to *2
in this program. (For the example with *2, refer to the following.)
*2 Example of adding initial setting items (Rate control function)
Note) When adding this program to the normal-mode D/A conversion program
(shown in Section 6.2.2), replace the existing initial setting program with the
program marked *1.
(c) When switching the mode by making intelligent function module switch
setting
Only the common program is necessary.
MELSEC-Q
Rate control
enable/disable setting
CH1 Increase digital
limit value
CH1 Decrease digital
limit value
4 - 15