Mitsubishi Electric MELSEC Q Series User Manual page 144

7 ONLINE MODULE CHANGE
7 - 21
(4) Operation check
(a) To make an operation check, click the [Cancel] button to cancel control
resumption.
(b) Click the [OK] button to stop the "Online module change" mode.
(c) Click the [Close] button to close the System monitor screen.
(d) On the pass data screen of GX Configurator-DA, set the prerecorded
values and perform User range writing request. (Refer to Section 5.6.3.)
(e) On the Operating condition setting screen of GX Configurator-DA, set
"Enable" in the Setting value field of used channels CH
enable/disable setting.
MELSEC-Q
D/A conversion
7 - 21