Jog Operation Data - Mitsubishi Electric MR-MQ100 User Manual

8 PARAMETERS FOR POSITIONING CONTROL

8.3 JOG Operation Data

mm
No. Item
Setting
Units
range
JOG
0.01 to mm
1 speed limit
6000000.00 /min
value
Parameter
2 block
setting
(Note-1): When the "speed control 10 multiplier speed setting for degree axis" is set to "valid", the setting range is 0.01 to 21474836.47[degree/min].
(1) The settings for JOG operation is executed.
(2) Individual start or simultaneous start can be used in JOG operation.
(3) JOG operation can be executed using the Motion SFC program or test mode of
MT Developer2.
(Refer to the help of MT Developer2 for JOG operation method in the test mode of
MT Developer2.)
(4) Refer to "Q173DCPU/Q172DCPU Motion controller (SV13/SV22) Programming
Manual (REAL MODE)" for details.
Table 8.3 JOG operation data list
Setting range
inch degree
Setting Setting
Units
range range
0.001 to
0.001 to inch
2147483.647
600000.000 /min
(Note-1)
1 to 64
Initial
PLS
value
Units Setting range
Units
1 to PLS
degree/
20000 PLS/s
2147483647 /s
min
1
8 - 4
Units Remarks
• Sets the maximum speed at the JOG
operation.
• If JOG speed setting exceeds the JOG
speed limit value, it is controlled with JOG
speed limit value.
• Sets the parameter block No. to be used at
the JOG operation.