Operating System Software Installation Procedure - Mitsubishi Electric MR-MQ100 User Manual

5 TRIAL OPERATION AND ADJUSTMENT

5.3 Operating System Software Installation Procedure

The operating system software can be installed to the Motion controller from a
computer running MT Developer2.
The installation procedure is shown below.
Set the first rotary switch (SW1) of the
motion controller to position "A". (Rotary
switch 2's (SW2) position does not matter)
Turn ON the Motion controller power
supply.
Install the operating system software
using MT Developer2.
Turn OFF the Motion controller power
supply.
Set the both rotary switches (SW1 and
SW2) of the motion controller to position
"0".
POINT
(1) The operating system software is installed at the time of Motion controller
purchase. It is necessary to install operating system software again after any
upgrades.
(2) Be sure to change the rotary switches only after first turning off the power
supply.
(3) Even if the operating system software is installed, the programs, parameters
and absolute position data written to the Motion controller is not overwritten.
(4) Do not do any of the following while installing operating system software.
Doing so could result damage the Motion controller.
• Turn off the motion controller's power supply.
• Change the RUN/STOP/RESET switch of Motion controller to RESET.
• Turn off the power supply of the personal computer.
• Pull out the personal computer's communications cable.
START
Shipped from the factory in
SW1 "0", SW2 "0" position.
END
5 - 6
Set to installation mode.
Refer to Section 2.5.1(3) for rotary switch.
Steady "INS" display.
Set to mode operated by RAM.