Mitsubishi Electric MR-MQ100 User Manual page 217

12 COMMUNICATION
(g) Transfer Setup of the computer (MT Developer2)
Select "Connection via Hub" on the Transfer Setup screen.
Transfer Setup
(Online > Transfer Setup)
"CPU side I/F Detailed Setting of PLC Module"
Select "Connection via Hub"
Set the IP address to the same value as the IP address of the Motion
controller.
The default value of the IP address is [192.168.3.39]
Refer to part (2) of this chapter below regarding the IP address setting.
"PC side I/F Ethernet Board Setting"
Select TCP or UDP to be same as "Open Setting"
Select "Ethernet Board"
Select "CPU Module" .
Choose this setting.
12 - 6
Select "Connection via Hub"
Set IP address
Refer to (2), on next page