Sscnet Cable - Mitsubishi Electric MR-MQ100 User Manual

4 INSTALLATION AND WIRING
4.2 Cable Connection and Disconnection
4.2.1 SSCNET cable
(1) Precautions for handling the SSCNET
• Do not stomp on the SSCNET cable.
• When laying the SSCNET cable, be sure to secure the minimum cable bend
radius or more. If the bend radius is less than the minimum cable bend radius, it
may cause malfunctions due to characteristic deterioration, wire breakage, etc.
• Hold the cable connector securely during connection and disconnection of the

SSCNET cable.

(2) Connection of SSCNET
• For connection of SSCNET cable to the Motion controller, connect it to the
SSCNET connector CN1 of the Motion controller while holding the SSCNET
cable connector's tab. Be sure to insert it until it clicks.
• If the cord tip of the SSCNET cable is dirty, optical transmission may be
interfered and may result in malfunctions. If it becomes dirty, wipe with a
bonded textile or similar. Do not use solvent such as alcohol.
(3) Disconnection of SSCNET
• For disconnection of SSCNET cable, pull the cable out while holding the
SSCNET cable connector's tab or the connector itself.
• After disconnection of SSCNET cable, be sure to replace the protective cap
(attached to Motion controller or servo amplifier) to the Motion controller and
servo amplifier.
• For SSCNET cable, attach the optical fiber protective tube to the end of the
connector.
Motion controller
PULL
CN1
cable
cable
4 - 6
cable