Connecting The Instrument Hose; Replacing The Instrument - Dentsply Sirona Intego Operating Instructions Manual

Dentsply Sirona
Operating Instructions Intego
64 5 7 4 98 D3543
D3543.201.01.08.02 02.2020
4.5.9.5

Connecting the instrument hose

ü Colored marks and position of guide lugs on motor and hose
coupling of the instrument hose match.
1. Slide back the cap nut at the hose coupling.
2. Attach the motor onto the hose coupling up to the stop, observing
the contact pins and tubes. Make sure the hose coupling does not
tilt.
Ä The arrow on the hose coupling and the notch on the motor
must face each other.
3. Press the cap nut gently onto the thread; then turn it
counterclockwise until a faint click is heard.
4. Screw the cap nut tightly onto the motor clockwise.
Does water leak out between the motor and the hose connection?
1. Remove the motor from the instrument hose.
2. Reconnect the motor to the instrument hose. Make sure it is
connected properly.
3. If water still leaks, replace the sealing washer.
4.5.9.6

Replacing the instrument

CAUTION
The instrument should only be fitted or removed when the motor is at
standstill.
Attach the instrument / adapter to the BL E motor
CAUTION
Do not operate the BL E motor with exposed motor shafts and
attachments (removed instrument / adapter). This may cause injury!
ü The motor is at a standstill.
➢ Attach the instrument or adapter. Lock the instrument or adapter
into place here by turning.
Attach instrument to the BL ISO E motor or adapter
ü The motor is at a standstill.
1. Align the nib A of the instrument with the groove B of the motor.
2. Insert the instrument until it snaps into place.
Removing instrument/adapter
ü The motor is at a standstill.
➢ Detach the instrument or adapter. Do not pull on the instrument
hose while doing this.
4 Operation
4.5 Dentist element
105