Tumbler Filling With Automatic Sensor Control - Dentsply Sirona Intego Operating Instructions Manual

Dentsply Sirona
Operating Instructions Intego
64 5 7 4 98 D3543
D3543.201.01.08.02 02.2020
4.7.2.3

Tumbler filling with automatic sensor control

The automatic sensor control is an option on the Comfort water unit and
is not available in all countries.
With this tumbler filler, the sensor control automatically detects the filling
level of the tumbler.
If the tumbler is removed before the preset filling level has been
reached, the water flow stops immediately.
Filling the tumbler
ü The tumbler must not be transparent.
ü The tumbler must always be placed in the center of the area
provided for it.
➢ Place the tumbler under the tumbler filler.
Ä The tumbler is filled automatically.
Ä After the preset filling level has been reached, the water flow stops
automatically.
If required, the tumbler can be refilled manually by the Tumbler filling
key, see "Tumbler filling on the EasyPad" [→ 159] or"Tumbler filling on
the EasyTouch" [→ 160].
IMPORTANT
Tumbler filling after switch-on
If an empty tumbler is standing below the tumbler filler when the
treatment center is switched on, the tumbler will not be filled
automatically. To activate automatic tumbler filling, remove the
tumbler briefly and then put it back again.
Setting the filling level
The tumbler filling level can be preset.
1. Open the maintenance flap A on the base of the water unit.
2. Set the filling level with control knob B.
4 Operation
4.7 Water unit
161