Turbine / Air Motor / Other Air-Driven Instruments; Using The Highspeed Handpiece; Setting The Light Of The Highspeed Handpiece - Dentsply Sirona Intego Operating Instructions Manual

4 Operation
4.5 Dentist element
10:45:03
S 0
A
1 2
98
4.5.8

Turbine / air motor / other air-driven instruments

IMPORTANT
Please see the operating instructions for the various turbines, air
motors, or air-driven instruments.
The turbine hose has a standardized coupling as per ISO 9168.
If your treatment center is equipped with the pneumatic foot switch, the
drive air for the turbine can be regulated by the foot pedal.
If instruments with a high air flow rate (e.g., SIROBoost from Dentsply
Sirona) are operated with the pneumatic foot switch, the operating
pressure is reduced from 2.9 bar to 2.7 bar.
4.5.8.1

Using the highspeed handpiece

EasyPad user interface
When the highspeed handpiece is removed from the holder, a short
vertical bar appears on the right side of the EasyPad display. Press the
foot switch to start the instrument.
EasyTouch user interface
When the highspeed handpiece is removed from the holder, a
highspeed handpiece signal appears on the touchscreen.
4.5.8.2

Setting the light of the highspeed handpiece

The instrument light supply is optional in Intego.
Halogen lamps cannot be operated with the Intego / Intego Pro
treatment centers.
The voltage or current can be limited for the LED lamp of the highspeed
handpiece. The power supply for the instrument light can also be
switched off.
The original Dentsply Sirona LED lamps are usually operated at 3.6 V.
For lamps made by other manufacturers, the settings may have to be
adjusted.
NOTE
The operating voltages and operating currents of different lamps may
vary.
Overvoltages or excess current can lead to damage.
➢ When changing lamps, make sure that the operating voltage or
operating current is properly set for the new lamp.
Dentsply Sirona
Operating Instructions Intego
64 5 7 4 98 D3543
D3543.201.01.08.02 02.2020