Others - Epson SC-F3000 Series User Manual

SC-F3000 Series User's Guide
3. If there is not enough white after doing 1 and 2
Contact your dealer or Epson Support.
The under-base white is showing
outside the image
Adjust the print area of the under-base white
o
in the software.
The printed under-base white may show outside the
image depending on the material of the T-shirt and
the amount of ink fired. If this occurs, adjust the print
area of the under-base white from the printer's
Garment Creator for SC-F3000 Series software or the
RIP software.

Others

The control panel display keeps
turning off.
Is the printer in sleep mode?
o
Normal operation can be restored by pressing any of
the buttons in the control panel to reactivate the
display and then performing a hardware operation
such as opening the printer cover or sending a job to
the printer. You can change the time until going into
sleep mode from
Basic Settings - Sleep Timer.
"Menu List" on page 106
U
Printing does not stop or printed text
is corrupted
Have you started Garment Creator for
o
SC-F3000 Series and software RIP over a USB
connection?
Only start Garment Creator for SC-F3000 Series or
software RIP. Do not run them both at the same time.
Areas not printed are stained with ink
Is the platen clean?
o
The platen's frame and the top plate may be stained.
Check the platen and clean it if necessary.
"Cleaning the Platen Without a Grip Pad" on
U
page 88
Problem Solver
(menu) - General Settings -
The printer status and log are printed
over the edges of the paper
Are you printing with an M size (standard)
o
platen?
Depending on the paper size the print area may
extend beyond the edges of the paper if it is loaded on
an optional platen. Load paper on the M size
(standard) platen, and then print.
"Load the T-shirt (media)" on page 59
U
Printing is slow or stops half way
Is the head move direction set to
o
uni-directional?
Uni-Direction (Low Speed) may be set for Print
Direction in Garment Creator for SC-F3000 Series, the
software for the printer. Try setting Bi-Direction
(High Speed) for Print Direction in Garment Creator
for SC-F3000 Series.
When doing repeat printing or to print a job from a
USB memory stick that has already been set to
Bi-Direction (High Speed), Head Move Direction
may be set to Uni-Directional on the preview screen.
Try changing the setting to Auto.
"When reprinting (repeat printing) the same job"
U
on page 70
"Printing from a USB Memory" on page 73
U
Are you using a USB memory stick with a slow
o
reading speed?
If you use a USB memory stick with a slow reading
speed (4.63 MB/sec or less) when printing from a USB
memory stick, the print head stops at times during
printing and printing continues. Use a USB memory
stick with a fast reading speed.
131