Opening The Pre-Treatment Liquid - Epson SC-F3000 Series User Manual

SC-F3000 Series User's Guide
C
Turn it to the left five times.
Rotate at a speed of about one turn every two
seconds.
D
Turn it to the right five times.
Rotate at a speed of about one turn every two
seconds.
E
Turn the box so that the section where the tap
comes out is at the top.
Basic Printing
Opening the pre-treatment
liquid
A
Cut the cardboard along the perforations, and
then remove the tap from inside.
B
Pull the cap section out of the hole in the
cardboard.
c
Important:
Make sure you pull the cap section out of the
hole in the cardboard. If the cap is opened
without being pulled out, the pre-treatment
liquid may spill out.
C
Remove the cap.
41