Epson SC-F3000 Series User Manual page 104

SC-F3000 Series User's Guide
A
Confirm that the power is turned on, and then
press in the order of
Keeping Preparation.
B
Check the on-screen messages, and then press
Start.
C
If there is waste ink in the Waste Ink Bottle,
replace it with a new one.
"Disposing of Waste Ink" on page 92
U
D
See the ink supply unit replacement procedure
and replace color ink and White ink with
cleaning liquid.
"Shaking and Replacing Ink Supply Units"
U
on page 89
E
Before storing them, clean off any ink stuck on
the ink supply ports of the ink supply units that
you removed.
Lightly touch the corner of a wide Cleaning Stick
from the supplied Maintenance Kit to the hole of
the ink supply port to absorb the ink. You do not
need to wipe off the ink.
Use a new Cleaning Stick for each color to avoid
mixing the colors. Do not forcefully press or
move the Cleaning Stick.
F
When the replacement complete message is
displayed, turn off the power.
Maintenance
(menu) - Maintenance -
104
Observe the following precautions when storing the
printer and the partially used Ink Supply Units that were
removed.
"Notes for when not using the printer" on page 23
U
"Notes on Handling Ink Supply Units/Cleaning Ink
U
Supply Units" on page 24
Restarting use of the printer
c
Important:
When restarting use of the printer, charge the
printer with ink. When charging with ink supply
units that were removed, have new ink supply units
on hand as a precaution.
Turn on the printer, and then follow the instructions on
the control panel to replace the Waste Ink Bottle and
install the Ink Supply Units.
"Replacing the waste ink bottle" on page 92
U
"Shaking and Replacing Ink Supply Units" on
U
page 89
Note:
The next time the printer is turned on and White ink
mode is used, the density of the White ink may be low. If
the density is too low, see the following.
"Not enough or uneven whiteness" on page 130
U