Loading On Medium Grooved Platens - Epson SC-F3000 Series User Manual

SC-F3000 Series User's Guide
c
Important:
Stretch the T-shirt so that there are no creases
or slack. However, if the T-shirts is stretched
too much, the print quality may decline due to
deformation of the image, and the white
under-base print may extend outside the
image.
I
Press down the frame of the platen so that it does
not become loose.
J
Tuck in the T-shirt around the frame so that it
does not drape over the movable base.
Loading on Medium Grooved
Platens
A
Press the P button to turn on the printer.
B
Check that the platen is ejected forward.
If it is not ejected, press the } button to move the
platen forward.
Basic Printing
C
On the printer's screen, confirm that the platen
position is as shown below.
When Platen Gap is set to Auto:
The optimum platen position varies depending
on the thickness of the media. Use the following
guideline to change the platen position.
Media thickness
0 mm to 4 mm
4 mm to 7 mm
7 mm to 10 mm
10 mm to 13 mm
13 mm to 16 mm
16 mm to 19.5 mm
When Platen Gap is set to Manual:
The optimum platen position varies depending
on the thickness of the media being loaded and
the type of platen being used. See the following
for more details.
"Table for Platen Gap setting values for
U
media thicknesses" on page 142
See the following for how to change the platen
position.
"How to change the platen position" on
U
page 58
67
Platen position
3
4
5
6
7
8