Loading On Sleeve Platens - Epson SC-F3000 Series User Manual

SC-F3000 Series User's Guide
c
Important:
Do not hang hanger platens on the hooks. They
could fall on the floor and be damaged.
Depending on the type of frame, only hang one as shown
in the illustration.
❏ Frames for L/M size hanger platens and
medium grooved platens
❏ Frames for S size hanger platens
❏ Frames for XS size platens as well as sleeve
platens

Loading on Sleeve Platens

A
Press the P button to turn on the printer.
B
Check that the platen is ejected forward.
If it is not ejected, press the } button to move the
platen forward.
Basic Printing
C
On the printer's screen, confirm that the platen
position is as shown below.
When Platen Gap is set to Auto:
The optimum platen position varies depending
on the thickness of the media. Use the following
guideline to change the platen position.
Media thickness
0 mm to 4 mm
4 mm to 7 mm
7 mm to 10 mm
10 mm to 13 mm
13 mm to 16 mm
16 mm to 19.5 mm
When Platen Gap is set to Manual:
The optimum platen position varies depending
on the thickness of the media being loaded and
the type of platen being used. See the following
for more details.
"Table for Platen Gap setting values for
U
media thicknesses" on page 142
See the following for how to change the platen
position.
"How to change the platen position" on
U
page 58
65
Platen position
3
4
5
6
7
8