Installation Instructions; Mount The Ivu Bcr; Cable Connections - Banner iVu Plus BCR Gen2 Series Instruction Manual

iVu Plus BCR Gen2 Series Sensor

4 Installation Instructions

4.1 Mount the iVu BCR

The iVu BCR requires a bracket for mounting. Brackets are available from Banner Engineering. See
www.bannerengineering.com
adjustable angle.
1. Position the iVu BCR on the bracket.
2. Thread three M4 x 4 mm screws (supplied) through the bracket into the mounting holes in the bottom of the iVu
BCR.
3. Tighten all three screws.
4. Mount the iVu BCR and bracket to the machine or equipment at the desired location. Do not tighten the mounting
screws at this time.
5. Check the iVu BCR alignment.
6. Tighten the mounting screws to secure the iVu BCR and the bracket in the aligned position.

4.2 Cable Connections

The cable connections on the iVu BCR are shown below, and power I/O connections (B) are defined in the Power I/O
Connections table below.
CAUTION: Electrostatic Discharge
Avoid the damage that electrostatic discharge (ESD) can cause to the Sensor.
Always use a proven method for preventing electrostatic discharge when installing a lens or attaching a
cable.
A
C
Figure 7. iVu BCR Cable Connections—Micro Video Lens
Model
Table 3: Power I/O Connections
Pin # Wire Color
1 White
2 Brown
3 Green
4 Yellow
18
. The brackets allow the iVu BCR to be mounted either perpendicular to the part or at an
Figure 6. Mounting Bracket Mounting Holes
A
B
C
D
B
D
Description
Output 1
10 V dc to 30 V dc
Output 2
Strobe Out (5 V dc only)
www.bannerengineering.com - Tel: + 1 888 373 6767
Remote Display Connector (remote display models only)
Power and I/O Cable Connector
USB Connector
Ethernet Connector
Note: Micro video lens model shown, C-Mount
model connections are identical.
Direction
Output
Input
Output
Output