Scan Time Limit - Banner iVu Plus BCR Gen2 Series Instruction Manual

• Show last read data—Use the last read barcode data for the data compare
• Edit—Enter data using a software keyboard on the display
• Mask—Select characters in the data to mask from the data compare
Edit Compare Data
Click Edit to access the Edit screen. The Edit screen displays data that was previously read or entered in the text field.
Position displays the position of the cursor within the characters displayed ([). Length indicates the number of characters.
Use the left and right arrows below the software keyboard to move the cursor between the displayed characters. Place the
cursor to the right of any character and use the back-arrow delete that character. Use the button at the bottom right of the
screen to cycle through different character entry keyboards: text entry (with a button to toggle between upper- and lower-
case characters), numeric entry, special character entry, and hex character entry.
Last Read Data
Click Show last read data to use the last read barcode data for the data compare.
Mask Data
Click Mask to enter the Mask screen and to select characters in the data to mask from the data compare.
To mask characters in the data, move the cursor to the left of the character(s) to be masked, and click Mask. A masked
character appears gray with a strikeout (\) indicator. To unmask a previously masked character, click UnMask. Note that,
when using Remote Teach to set new barcode data, if the previous input data contained any masked characters, Remote
Teach retains the masked characters only if the new data is of the same length as the previous input data. If the length does
not match, masking is removed.

9.1.4 Scan Time Limit

Use the slider to set the maximum amount of time the sensor attempts to decode barcodes in an image. The trigger mode
External - Gated uses this value.
www.bannerengineering.com - Tel: + 1 888 373 6767
iVu Plus BCR Gen2 Series Sensor
45