Inputs To Ivu Bcr (Outputs From Plc); Outputs From Ivu Bcr (Inputs To Plc) - Banner iVu Plus BCR Gen2 Series Instruction Manual

14.6.2 Inputs to iVu BCR (Outputs from PLC)

The registers below are used by the PLC to push values to the iVu BCR device. MSG (message) commands are used to
write (N14) to the iVu BCR.
Barcode Type Numeric Codes
See
Table 21: PCCC PLC Output Registers (iVu BCR Inputs, N14 Table)
WORD # WORD NAME
0 Input Bits Register (see
1-2 Product Change Number
3-49 reserved
50 Command ID
51 Command Parameter Int16
52-53 Command Parameter Int 32
54-55 Command Parameter
56-57 Command Parameter String Length
58-107 Command Parameter String
reserved
108
109-110 BCR String/Mask Length
111-120 BCR String/Mask
211-239 reserved

14.6.3 Outputs from iVu BCR (Inputs to PLC)

The registers below are used to send output values from the iVu BCR device to the PLC. MSG (message) commands are
used to read (N7) from the iVu BCR.
To Address = IP address of the iVu BCR
Figure 118. MultiHop tab: IP address of the iVu BCR is entered here
(p. 105) for additional information.
Input and Output Flags
www.bannerengineering.com - Tel: + 1 888 373 6767
DATA TYPE
(p. 129)) 16-bit integer
32-bit integer
32-bit integer
16-bit integer
16-bit integer
32-bit integer
Float
32-bit integer
100-Byte Array
16-bit integer
32-bit integer
200-Byte Array
16-bit integer
iVu Plus BCR Gen2 Series Sensor
127