Command Channel Reference - Banner iVu Plus BCR Gen2 Series Instruction Manual

iVu Plus BCR Gen2 Series Sensor
8. Get the barcode data read by the iVu sensor.
>> get bcr_result data\x0D\x0A
<< OK\x0D\x0A
<< "0043000011201"\x0D\x0A

13.4.4 Command Channel Reference

Info Command Group
Command Group
Get Info
Get Info
Get Info
Get Info
Get Info
Get Info
Get Info
Get Info
Get Info
Get Info
Get Info
Examples
>> get info companyname\x0D\x0A
<< OK\x0D\x0A
<< "Banner Engineering Corp."\x0D\x0A
>> get info bootnumber\x0D\x0A
<< OK\x0D\x0A
<< 42\x0D\x0A
>> get info uptimer\x0D\x0A
<< OK\x0D\x0A
<< 4:42:42:324\x0D\x0A
System Command Group
Command Group
Do System
Do System
Get Ethernet
Get Ethernet
Get Ethernet
Set Ethernet
86
Item Description
CompanyName The company name as a string.
ModelNumber The device model number as a string.
FirmwareVersion The device firmware version as a string.
SerialNumber The device serial number as a string.
Name The device name as a string.
BootNumber The number of device bootups.
UpTimer The elapsed time the device has been running. The format is
hh:mm:ss:msec.
HourCount The number of hours the device has been running.
RemoteConnected The remote display connected status as a Boolean value (true or false).
RemoteModelNumber The model number of the remote display as a string.
RemoteSerialNumber The serial number of the remote display as a string.
Item Description
Reboot Reboots the device. Pre-empts other commands except Save.
Save Saves inspection and configuration parameters. Blocks until finished.
Should be used sparingly.
IPAddress Get the current active IP address of the device as a string.
SubnetMask Get the current active subnet mask of the device as a string.
Gateway Get the current active Gateway address of the device as a string.
IPAddress Set the IP address of the device. A valid IP address must be supplied as
a string (for example: 192.168.0.1). A Reboot command from the
command channel must follow to make the new IP address effective.
You may also set new Subnet Mask and Gateway address as required
before a Reboot command is sent to the device.
www.bannerengineering.com - Tel: + 1 888 373 6767