Install The Software - Banner iVu Plus BCR Gen2 Series Instruction Manual

iVu Plus BCR Gen2 Series Sensor
Note: The light/lens assembly may include an integrated ring light or a blank disk if an integrated
ring light is not used. Be careful that the light/lens assembly does not pull out when removing the
focusing window. Pull gently on the focusing window. If the lens assembly moves with the
window, continue to rotate the window clockwise until the lens assembly does not move.
3. Set the focusing window aside. Do not to get any debris on the window's O-ring.
4. If present, remove the protective covering on the filter.
5. Place the filter into the filter cap and press the cap onto the lens.
6. After the filter is installed, place the focusing window back into the housing while inserting the locking clip into the
groove as shown.
7. Press the focusing window onto the housing to make sure that there is no gap between the window and the
housing. Rotate the window counter-clockwise at least two turns.
8. Replace the locking tab screw but do not tighten it until you have set up and focused the iVu BCR again.
Installing a Filter on the C-Mount Lens Model
To install a filter on the iVu BCR with C-Mount lens, use the illustration as a guide and follow the steps listed below.
CAUTION: Failure to follow these instructions may cause damage to your iVu BCR.
Note: Filter kits are available separately.
1. Remove the lens enclosure and C-mount lens.
2. Install filter behind the retainer ring. Make sure it is fully seated.
3. Using the provided retainer ring tool, thread the retainer ring into the iVu BCR until it firmly seats the filter.
4. Replace the lens and lens enclosure on the iVu BCR.

4.4 Install the Software

Important: Administrative rights are required to install the Vision Manager software.
1. Download the latest version of the software from
2. Navigate to and open the downloaded file.
3. Click Next to begin the installation process.
20
Groove
Figure 9. Locking Clip in the Groove
C
E
B
D
C
A
Figure 10. C-Mount Lens Model Components
www.bannerengineering.com - Tel: + 1 888 373 6767
B
C
A C-Mount Lens
B Lens Enclosure
C Retainer Ring
D Filter
E Filter Retainer Ring Tool
www.bannerengineering.com
.