Firmware Update; Ivu Trigger, Remote Teach, And I/O Waveforms; Pnp (Low-To-High) Trigger And Remote Teach Input Waveforms; Npn (High-To-Low) Trigger And Remote Teach Input Waveforms - Banner iVu Plus BCR Gen2 Series Instruction Manual

iVu Plus BCR Gen2 Series Sensor
Note: This option is not available on the Emulator.

11.9 Firmware Update

Main Menu > System > Firmware Update
Use the Firmware Update screen to load the latest device firmware. The Firmware Update screen lists the firmware versions
it finds in the BANNER\FIRMWARE folder on the USB flash drive. When you receive a firmware update from Banner
Engineering, be sure to put it in the BANNER\FIRMWARE folder on the USB flash drive.
Note: The Firmware Update menu is not available in the Emulator.

11.10 iVu Trigger, Remote Teach, and I/O Waveforms

The iVu BCR has two input signals—Trigger and Remote Teach. The default setting is to detect the low to high transition.
To change this setting, go to Main Menu > System > Discrete I/O > Input Polarity on the iVu BCR.
11.10.1 PNP (Low-to-High) Trigger and Remote Teach Input
Waveforms
Wire Color
Pink
Gray
The iVu BCR triggers from low to high, and Remote Teach behaves electrically like trigger.
Note:
Table 4: Required iVu Input Signal Voltage
PNP
11.10.2 NPN (High-to-Low) Trigger and Remote Teach Input
Waveforms
Wire Color
Pink
Gray
The iVu BCR triggers from high to low, and Remote Teach behaves electrically like trigger.
64
Power up
Function
Trigger
Remote
Teach
+10 V dc to 30 V dc
Power up
Function
Trigger
Remote
Teach
www.bannerengineering.com - Tel: + 1 888 373 6767
ON OFF
< 2 V dc