Installing A Filter On An Ivu Bcr - Banner iVu Plus BCR Gen2 Series Instruction Manual

Pin # Wire Color
5 Gray
6 Pink
7 Blue
8 Red
9 Orange
10 Light Blue
11 Black
12 Violet

4.3 Installing a Filter on an iVu BCR

Installing a Filter on the Micro Video Lens Model
To install a filter on the iVu BCR with Micro Video Lens, use the illustration as a guide and follow the steps listed below.
CAUTION: Failure to follow these instructions may cause damage to your iVu BCR.
CAUTION: Electrostatic Discharge
Avoid the damage that electrostatic discharge (ESD) can cause to the Sensor.
Always use a proven method for preventing electrostatic discharge when installing a lens or attaching a
cable.
Note: Filter kits are available separately.
1. Remove the locking screw (D) using the 1/16-inch hex key.
Note: The locking clip (C) inserts in a groove near the top of the focusing window (B). When
removing the window, the locking clip will be loose. Do not to lose the clip while removing the
window.
2. Unscrew the focusing window by turning it clockwise approximately 5 complete turns or until the focusing window
disengages from the light/lens assembly.
Description
Remote Teach
External Trigger
Common (Signal Ground)
Ready
Output 3
RS-232 TX
RS-232 Signal Ground
RS-232 Rx
A Lens
B Focusing Window
C Locking Clip
D Locking Screw
E Filter Cap
F Filter
Figure 8. Micro Video Lens Model Components
www.bannerengineering.com - Tel: + 1 888 373 6767
iVu Plus BCR Gen2 Series Sensor
Direction
Input
Input
Input
Output
Output
Output
Output
Input
19