Troubleshooting; Led Indicator Troubleshooting; Errors; Warnings - Banner iVu Plus BCR Gen2 Series Instruction Manual

Hide thumbs Also See for iVu Plus BCR Gen2 Series:

Quick start manual (13 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

125

126

127

128

129

130

131

132

133

134

135

136

137

138

139

140

141

142

143

144

145

146

147

148

149

150

151

152

153

154

155

156

157

158

159

160

161

162

163

164

165

166

167

168

169

170

171

172

173

174

175

176

177

178

179

180

181

182

183

184

185

186

187

188

189

190

191

192

193

194

195

196

197

198

199

200

201

202

203

Table of Contents

iVu Plus BCR Gen2 Series Sensor

15 Troubleshooting

15.1 LED Indicator Troubleshooting

In normal operation, the Power LED is green, and the Pass/Fail is green or red depending on the triggered inspection. The

Ethernet I/O LED is on or off depending on connection status.

Figure 193. iVu BCR LEDs

The iVu BCR LEDs also indicate abnormal conditions as described in

15.1.1 Errors

Indicator

The Pass/Fail LED blinks green deveral times,

separated by an LED red blink, and the iVu

BCR repeats this pattern over and over. This

indicates that no inspections are occurring.

The Power LED is on steady red. Errors

indicated by the Power LED are reported in the

System log and appear highlighted in red.

15.1.2 Warnings

Warnings are atypical conditions that the iVu BCR detects and fixes. Warnings are highlighted in yellow in the System Log,

and can typically be ignored.

15.2 How to Round-Trip Debug Using the Emulator

This section describes the procedures for performing round-trip debugging using the iVu BCR Emulator in Vision Manager.

Note: This section refers to saving configuration and inspection logs in folders based on the device name.

If the device is not named, folders are named using the first eight characters of the device serial number.

Two options are available:

•

How to Debug Using Inspection Logs

How to Debug Using Bitmap Files

•

182

1. Power LED

2. Pass/Fail LED

3. Ethernet I/O LED

Solution

Reboot the iVu BCR device.

1. Look at the System Log to see the error.

2. Clear the LED.

a. Go to Main Menu > Logs > System Logs .

b. Click Clear System Error. A device reboot is not required.

3. If the error occurs again, try rebooting the iVu BCR to see if that

fixes the problem. If the problem persists, contact Banner

Engineering.

(p. 183)

www.bannerengineering.com - Tel: + 1 888 373 6767

Green: Ready/Power

Red (blinking or steady): Error

Green (steady): Pass

Green (blinking): Error

Red: Fail

Green: Connected

Off: Disconnected

Errors

(p. 182).

Table of Contents