When the PSU is outside the chassis (not installed), do not plug the
PSU into an electrical outlet. Plugging an uninstalled PSU into an
electrical outlet exposes you to a hazardous energy and is a
potential fire hazard.
Install a PSU
To install the PSU:
Carefully slide the power supply all the way into the power supply bay until it clicks into
1.
place.
CAUTION:
Do not slam the power supply into the system backplane. Use the locking
handle to secure the power supply in the power supply bay.
Repeat step 1 to install each additional power supply.
2.
After all the power supplies are installed, connect an AC power cord to the AC input
3.
connector below each power supply.
WARNING:
Be sure that the source outlet is properly grounded before plugging
the AC power cord into the input connector.
NETGEAR M6100 Switch Chassis
Power Supply Units
20