Home Type2 . 3 - Newport MM4006 User Manual

MM4006
Newport. 2
L o
Press the U P k e y to advance to the next parameter.
Axis Setup 7 - MODIFY
QUIT ' QUIT
Motor Type
This parameter selects the type of motor to be used w i t h the motion
device. The two choices are Stepper and DC.
The motor type configured in the setup mode must match the actual
motor and driver installed on the specific axis.
If the displayed motor type is incorrect for the selected axis, press the
MODIFY k e y to change the setting. Press the CHANGE k e y to select a new
motor type. Press VALID t o accept the new selection and return to the
previous menu.
Press the U P k e y to advance to the next parameter.
Axis Setup
QUIT
HOME Type
All standard motion devices offered w i t h the MM4006 have an origin
(home) switch and they can all perform a home search cycle. In cases
where the controller is used with a device that does not have a home
switch, the controller must know not to look for it.
Use the HOME Type parameter to tell the controller if the home switch is
real (for standard devices with an origin switch) or if it should be simulat-
ed (for non-standard devices without a home switch). The simulated home
switch (sometimes called floating) is assumed to be at the current position
where the device is when the home search command is received.
If you need to change the HOME Type, press the MOArd key when the
parameter is displayed. Press the CHANGE key to select a new home switch
type. Press VALID t o accept the new type and return to the previous
menu.
Press the U P k e y to advance to the next parameter.
Axis Setup
QUIT ) . QUIT Y E S
. 3 1
c a
U P
MODIFY CHANGE V A L I D
' Y E S Q U I T
CAUTION
imply M O D I F Y
' QUIT
MODIFY UP MODIFY CHANGE V A L I D
Q U I T
l Mode
CHANGE -± VALID
ED1-10181En1020 — 03/03