Softwares3; Motion Suite - Newport MM4006 User Manual

MM4006 R
Softwares
3.2
M i e V V p O r t . 3
e m
In order to communicate with the controller, the user must have a terminal
or a computer capable of communicating with external devices via a RS-
232-C, RS-485 or IEEE-488 interface.
One approach is to use a communications software that can emulate a
terminal. An other solution is to use available NEWPORT MOTION Suite 32
softwares.
3.2.1 M O T I O N Suite 32
MOTION Suite 32 is a set of W i n d o w s ' " applications for the MM4006
Motion Controller.
MOTION Suite 32 requires the following minimum configuration:
• A n IBM PC or 100% compatible.
• A VGA monitor.
• A n 80486 or later processor.
• 1 6 MB of available memory.
• A CD-ROM drive.
• A hard disk.
• A 95/98 or NT Windowslm environment.
This software only accepts the following interfaces:
• R S -232-C: COM I or COM2 standard serial port.
• R S -485 interface port.
• IEE-488: GPIB National Instrument® board, model AT-GPIB/TNT.
Before using NEWPORT MOTION Suite 32 softwares, the IEEE-488 board
listed above must be into the initial configuration of the constructor, and
installed in accordance with its recommended procedure.
Before using NEWPORT MOTION Suite 32 softwares, we advise you to
use softwares utilities supplied with the IEEE-488 board to check that the
installation is completed successfully.
. 5
o t
(.7k.,,
l " g k f r k r 7 Co,,
Nii&VPCirt cop)Mgetaksctwa9ro
ATTENTION
E D H 0 1 8 1
e Mode
E n 1 0 2 0 — 03/03