Table of Contents
Advertisement
MM4006
EDI10181En I 020 — 03/03
L
o
Stop Bits
The stop bits must also be set to the same value on both the controller and
remote computer for RS-232-C or RS-485 communication.
The possible options are 1 and 2 bits. The factory default is set at 1 bit.
To change the RS-232-C stop bits setting from the General Setup menu
press U P u n t i l the Stop Bits parameter appears on the display. Press
MODIFY a n d then the CHANGE key to select a new value. Press the VALID
key to accept the entry and return to the previous menu.
Motor OFF
C H A N G E
CMSxx — Set serial communication Stop Bit number.
Word Length
The word length refers to the word size to be used with the RS-232-C and
RS-485 interfaces. The MM4006 controller is designed to accept either 7- or
8-bit words. The factory preset word size is 8 bits.
To change the RS-232-C word length from the General Setup menu, press
pegbt until the Word Length parameter appears on the display. Press
IVIODO and then the CHANGE key to select a new value. Press the VALID
key to accept the entry and return to the previous menu.
Motor OFF
C H A N G E
CMLxx — Set serial communication data length.
c
a
SETUP G E N .
V ALID Q U t t l
Q U I T
SETUP G E N .
V ALID —" QUIT * QUIT
2.12
i
k
l
l
UP
— MODIFY
UP
MODIFY
e
v
v
p
o
Mode
r
t
.
Advertisement
Chapters
Table of Contents
