Tyre Pressure Loss Indicator - Seat Tarraco 2020 Owner's Manual

WARNING
The use of unsuitable or incorrectly fitted
chains could lead to serious accidents and
damage.
Always the appropriate snow chains.
●
Observe the fitting instructions provided
●
by the snow chain manufacturer.
Never exceed the maximum permitted
●
speeds when driving with snow chains.
CAUTION
Remove the snow chains to drive on
●
roads without snow. Otherwise they will im-
pair vehicle handling, damage the tyres
and wear out very quickly.
Wheel rims may be damaged or scratch-
●
ed if the chains come into direct contact
with them. SEAT recommends the use of
covered snow chains.
Wheels

Tyre pressure loss indicator

Control lamp
 It lights up
The inflation pressure of one or more wheels is much
lower than the value set by the driver, or the tyre has
structural damage.
In addition, a audible warning sounds and a text
message is displayed on the instrument panel
screen.
Stop the vehicle! Stop the vehicle safely as soon

as possible. Check all tyres and pressures. Replace
any damaged tyres.
 Flashes
System fault
The control lamp flashes for approximately 1 minute
and then lights up permanently.
If the tyre is inflated correctly, switch the ignition off
and on again. Re-calibrate the tyre pressure loss in-
›››
dicator page 370. If the fault continues, go to a
specialised workshop.
Several control and warning lamps light up
for a few seconds when the ignition is switch-
ed on while the function is verified. They will
switch off after a few seconds.
WARNING
›››
Observe the safety warnings
trol and warning lamps on page
Tyre monitor system
Instrument panel: warning of loss of
Fig. 322
tyre pressure.
The tyre monitor indicator compares wheel
revolutions and, with this information, the
tread of each wheel using the ABS sensors.
If the rolling circumference of one or more
wheels has changed, the tyre monitoring indi-
cator will indicate this on the instrument pan-
el through a warning lamp and a warning to
›››
the driver Fig.
tyre is affected, its position within the vehicle
will be indicated.
Loss of pressure: Check left

tyre pressure!
Wheel tread change
in Con-
The wheel diameter changes when:
81.
Tyre pressure is changed manually.
●
Tyre pressure is insufficient.
●
322. When only one specific
»
369