Control - Seat Tarraco 2020 Owner's Manual

Air distribution / /
 
Turning regulator distributes the air to the
3
desired zone:
The airflow is directed towards the chest

The airflow is directed towards the chest

and the footwell area.
The airflow is directed towards the foot-

well.
The airflow is directed towards the wind-

screen and the footwell area.
Defrost/demist function
When control is in position
3
directed at the windscreen and air recircula-
tion is disconnected automatically or not ac-
tivated. Increase the fan power to clear the
windscreen of condensation as soon as pos-
sible. To dehumidify the air, the cooling sys-
tem will automatically switch on.
Maximum cooling power
When the control is in position
culation and the cooling system are connec-
ted automatically and the air flow is automat-
ically adjusted to position
Heated rear window

This only works when the engine is running
and switches off automatically after a maxi-
mum of 10 minutes.
156
/ / It should be switched off as soon as the glass
  
is demisted. By saving electrical power you
can also save fuel.
To avoid possible damage to the battery, an
automatic temporary disconnection of this
function is possible, coming back on when
normal operating conditions are re-establish-
ed.
Air recirculation
›››
page 158
Seat heating

›››
page 159
the air flow is

Switching off
Press button

air recir-

.

Operation

 
or manually set the fan to .
 
Operating the Climatronic through
the Easy Connect system*
Easy Connect screen: Climate control
Fig. 155
menu.
In the Easy Connect system it is also possible
to perform various adjustments to the Clima-
tronic.
Open the air conditioner menu
Press the button of the Climatronic
● 
control panel.
On the screen you can view and change the
current settings, such as, for example, the
temperature set for the driver and passenger
sides. Temperatures up to +22°C (+72°F) are
shown with blue arrows, and temperatures
over +22°C (+72°F) with red arrows.
To switch a function on or off, or to select a
submenu, you must press the corresponding
function button.