Seat Tarraco 2020 Owner's Manual page 327

The aerial view is generated by combining
the images from all the cameras
›››
Fig. 295. The aerial view can be selected
by pressing the vehicle in the area.
Select the corresponding view by pressing
›››
the different areas Fig. 295
aerial view or the reduced aerial view.
Conditions necessary for the use of the
Area View system
The doors and the rear lid must be closed.
●
The image must be reliable and clear. For
●
this reason, for example, the camera lens
must be clean.
The area around the vehicle must be clear-
●
ly and totally visible.
The area for parking or manoeuvring
●
should be a flat surface.
The vehicle should not be loaded very
●
heavily at the rear.
The driver must be used to the system.
●
There should be no damage to the vehicle
●
in the camera area. If the position or installa-
tion angle of the cameras have been
changed, e.g. after a rear-end collision, the
system should be checked by a specialised
workshop.
Special characteristics
The images on the area view system cameras
are only two-dimensional. Due to a lack of
Help with parking and manoeuvring
spatial depth, it is difficult or impossible to
make out on-screen any holes there may be

on the ground, objects jutting out from the
ground or parts protruding from other vehi-
cles.
to of the Situations in which the objects or other vehi-
A D
cles appear to be further away or closer than
they really are:
On moving from a horizontal plane to a
●
slope.
On moving from a slope to a horizontal
●
plane.
If the vehicle is heavily loaded at the rear.
●
If the vehicle approaches protruding ob-
●
jects. These objects may be outside the cam-
eras' angle of visibility.
Trailer mode
The Area View system conceals, in the rear
camera area, all the auxiliary guiding lines
when the factory-fitted towing bracket is
connected electrically to a trailer
›››
page 332.
Note
In order to become familiar with the system
and its functions, SEAT recommends that
you practice handling the Area View sys-
tem in an area where there is not too much
traffic or in a car park.
Connecting and disconnecting
Centre console: button to manually
Fig. 296
activate/deactivate the peripheral vision sys-
tem when combined with the park assist sys-
tem.
Manual activation
›››
Press button once Fig. 296.
● 
The infotainment system screen displays the
›››
aerial view Fig. 295. If you press the
button when driving at over 15 km/h (9 mph),
the image will not be displayed.
Automatic activation
Select reverse gear.
●
OR: The vehicle moves backwards.
●
The view of the image of the vehicle's rear
camera is shown in parallel parking mode
with the reduced aerial view.

»
325