CAUTION
For automatic switching off due to system
failures, for security reasons, the limiter is
only completely switched off when the
driver stops pressing the accelerator or
consciously switches it off.
Note
Different versions of the instrument panel
●
are available and therefore the versions
and instructions on the display may vary.
If the cruise control (GRA), the adaptive
●
cruise control (ACC) or the speed limiter
are connected when the ignition is switch-
ed off, the assistants will switch it when the
ignition is switched on, but only the speed
limiter will maintain the last programmed
speed.
272
Driving
Operating the speed limiter with
the turn signal lever
On the turn signal lever: buttons to
Fig. 254
operate the speed limiter.
Connecting
›››
Move control
Fig. 254
to position
●
1
and press button
.
2
The last programmed speed is stored. It does
not take effect yet.
Activating the speed limiter
›››
While driving, press button
●
the area
.
The current speed is stored as the maximum
speed.
Setting the programmed speed
You can set the speed using button
›››
Fig. 254
:
3
Briefly press area
●
small increments of 1 km/h (1 mph).
Press and hold the area
●
ously increase speed in increments of 10
km/h (5 mph).
Briefly press area
●
in small increments of 1 km/h (1 mph).
Press and hold area
●
decrease speed in increments of 10 km/h (5
mph).
The speed is limited to the set value.
Switching off the speed limiter
Move control
●
The system switches off.
Switching off temporarily
If you want to temporarily deactivate the
speed limiter, e.g. for overtaking, move the
›››
control
Fig. 254
press button
After overtaking, the speed limiter can be ac-
Fig. 254
in
3
tivated with the previously programmed
speed by pressing button
the area
to increase speed in
to continu-
to decrease speed
to continuously
›››
Fig. 254
to position
.
1
to position
or
1
.
2
›››
Fig. 254
in
3
.