Parking
If necessary, press the
button before
●
passing in front of the selected parking
space.
With reverse assist connected and in work-
●
ing order, press the function button
Turn on the corresponding turn signal on
●
the side of the road where you want to park.
Place the vehicle parallel to the parking
●
space, approx. 1 meter away.
If obstacles protrude from the auxiliary box-
●
es, find another parking space or realign the
vehicle.
Select reverse gear. A red frame represents
●
the target position of your vehicle.
Turn the steering wheel until the red frame
●
is between the auxiliary boxes and has
changed to green. Keep the steering wheel in
this position and start driving slowly.
When an arrow appears, reverse. A yellow
●
line and a green line appear. The arrow indi-
cates the distance that still has to be cov-
ered.
While reversing, keep the steering wheel in
●
the adjusted position. Adjust the steering
wheel rotation correctly when an indication
appears on the steering wheel symbol
Reverse until the STOP signal is shown or
●
until the green line matches up with the later-
al boundary of the parking space.
Help with parking and manoeuvring
Stop the vehicle. Turn the steering wheel as
●
far as it'll go in the opposite direction.
Reverse until the STOP signal is shown or
●
until the red line reaches the rear boundary.
.
Problems and solutions
The system behaves differently than ex-
pected
There can be several causes:
The camera is dirty
●
to dirt and snow, camera visibility can be re-
duced by detergent residue or any type of
coating.
The system requirements must be met
●
›››
page
329.
The camera is covered with water.
●
The factory-fitted towing bracket must not
●
be electrically connected to a trailer
›››
page
339.
The vehicle has some type of damage in
●
the camera area, e.g. due to a parking im-
pact.
The field of view of the camera is blocked
●
by an accessory, e.g. a bicycle carrier sys-
.
tem.
Changes have been made to the paint in
●
the camera area, or structural modifications
have been made to a component such as the
running gear.
Camera with no visibility, fault message,
the system disconnects
Clean the camera or remove possible ad-
●
hesives or accessories from it
Check for visible damage.
●
Possible solution
Temporarily disconnect the system.
●
Check if one of the causes indicated above
●
has occurred.
Once the source of the problem has been
●
›››
page
378. In addition
eliminated, the system may be reconnected.
If the system still behaves unpredictably,
●
have it checked by a specialised workshop.
›››
page
378.
331