example, in the event warnings indicating
road works, and snow, dirt, moisture or reflec-
tions.
When the radius of a curve is too small.
●
When no road markings can be seen.
●
When the distance to the next marking to
●
too great.
When the system does not detect any clear
●
and active steering movement during a long
period of time.
Temporarily, in the event of very dynamic
●
driving styles.
If a turn signal is activated.
●
With the stability control system (ESC) in
●
Sport mode or switched off.
BSD Plus (Lane Assist with Blind Spot As-
sist)*
The BSD Plus function is achieved by activat-
ing the Lane Assist and BSD functions
›››
page
291. In this case, the Lane Assist
function expands its functions in the following
way:
If the driver tries to change lane and there is a
vehicle in the blind spot:
The
lamp flashes in the corresponding
●
rear-view mirror even though the turn signal
has not been activated.
The steering wheel vibrates to warn the
●
driver of the risk of collision. This function can
288
Driving
be activated/deactivated in the Easy Con-
nect system with the button > SETTINGS
> Driver assistance > Lane Assist
›››
page
82.
torque is applied to correct the steering
●
and return the vehicle to its lane.
Switching off the Lane Assist system in the
following situations
Due to the limits of the Lane Assist system,
switch it off in the following situations:
When more attention is required of the driv-
●
er
When driving in a sporty style
●
In unfavourable weather conditions
●
On roads in poor condition
●
In areas of road works
●
WARNING
The intelligent technology in the Lane As-
sist system cannot change the limits im-
posed by the laws of physics and by the
very nature of the system. Careless or un-
controlled use of the Lane Assist system
may cause accidents and injury. The sys-
tem is not a replacement for driver aware-
ness.
Always adapt your speed and the dis-
●
tance to the vehicles ahead in line with visi-
bility, weather conditions, the condition of
the road and the traffic situation.
Always keep your hands on the steering
●
wheel so it can be turned at any time.
The Lane Assist system does not detect
●
all road markings. The road surfaces, road
structures or objects in poor condition can
be incorrectly detected as road markings
under certain circumstances by the Lane
Assist system. In such situations, switch the
Lane Assist system off immediately.
Please observe the indications on the in-
●
strument panel and act as is necessary.
Always pay attention to the vehicle's sur-
●
roundings.
When the area of vision of the camera
●
becomes dirty, covered or is damaged, the
Lane Assist system function can be affec-
ted.
CAUTION
In order to avoid influencing the operation
of the system, the following points must be
taken into account:
Regularly clean the area of vision of the
●
camera and keep it in a clean state, without
›››
snow or ice
Fig.
270.
Do not cover the area of vision of the
●
camera.
Check that the area of vision of the wind-
●
screen camera is not damaged.