Seat Tarraco 2020 Owner's Manual page 131

Press and hold the button
●

Within the following 10 seconds, push the
●
open button on the vehicle key. An audible

warning confirms the settings have been de-
activated.
Initialising the seat position memory
The position memory system must be restar-
ted if, for example, the driver seat has been
changed.
Restarting deletes all memories and assign-
ments for the seat with position memory. The
memory buttons can then be reprogrammed
and the vehicle keys re-assigned.
Open the driver door and do not get into
●
the vehicle.
Operating the seat settings from outside
●
the vehicle.
Move the angle of the seat backrest com-
●
pletely forwards.
Release the control to set the angle and
●
then press again until an audible warning is
heard.
WARNING
Adjust the memory function only when the
vehicle is stationary.
Seats and headrests
›››
Fig. 115.
Note
If the driver door is opened approx. 10 mi-
nutes after the vehicle was unlocked or lat-
er, the driver seat and the exterior mirrors
do not move automatically.
Access aid for the third row of seats
Second row of seats:: access aid con-
Fig. 116
trols.
The convenient entry function makes it easier
to access the third row of seats.
Folding down the backrest and moving the
second row seat
Remove any objects located in the footwell
●
of the second row of seats
Pull the release lever
●
rection of the arrow.
Fold down the backrest of the seat and
●
move the seat forward.
Enter the vehicle or leave the vehicle care-
●
›››
fully
Folding down the second row backrest
Move the rear seat to its rearmost position.
●
Pull the lever
●
rest backwards until it is in a vertical position.
The entire seat folds down
The rear seat must be correctly engaged
●
›››
If the convenient entry function is used
negligently or without due care, this may
cause accidents and serious injury.
Never use the convenient entry function
●
when the vehicle is in motion.
Avoid trapping or damaging the seat belt
●
when folding the rear seats back.
When moving the backrests up and down,
●
keep your hands, fingers, feet and other
body parts out of the operating area of the
hinges and the locking mechanism of the
seats.
Mats or other objects can be caught in
●
the hinges of the seat backrests or the
›››
.
seats themselves. This would cause the
›››
Fig. 116 in the di-
backrests and benches not to lock correct-
ly when moving the seats to the vertical po-
sition.
.
›››
Fig. 116 and push the back-
›››
.
.
WARNING
»
129