Seat Tarraco 2020 Owner's Manual page 165

Always keep the remote control, keyrings
●
with batteries, the spare batteries, button
batteries and all other batteries over 20
mm out of reach of children.
If you suspect that someone may have
●
swallowed a battery, seek immediate med-
ical attention.
CAUTION
The radio frequency remote control con-
●
tains electronic components. Therefore,
avoid getting it wet and exposing it to
knocks or direct sunlight.
The use of inappropriate batteries may
●
damage the radio frequency remote con-
trol. For this reason, always replace the
used battery with another of the same volt-
age, size and specifications.
For the sake of the environment
Please dispose of your used batteries
●
correctly and with respect for the environ-
ment.
The remote control battery may contain
●
perchlorate. Observe the legal provisions
regarding disposal.
Care should be taken so as not to oper-
●
ate the remote control unintentionally so
as to prevent the auxiliary heater being
switched on accidentally.
Air conditioning
Programming the auxiliary heater*
Before programming it, check that the vehi-
cle's date and time are set correctly
The auxiliary heater is programmed in the
menu of the infotainment
Auxiliary heater
system.
Open the Auxiliary heater menu.
Press the button of the Climatronic
●

control panel.
Press the function button.
●

Function button: function
: The auxiliary heater is immediately
Switch off
switched off.
, Ventilate : Set to heat or ventilate the vehi-
Heat
cle interior when the auxiliary heater is switched on.
Press the function button to select the desired

mode.
: Opens the Auxiliary heater menu.
Set
Function button: function
Departure time 1
, Departure time 3 : Three different de-
2
›››
.
parture times (hh.mm) may be programmed. If
the auxiliary heater should only be switched
on a certain day of the week, this can also be
selected.
: The duration determines the oper-
Duration
ating time of the auxiliary heater when switch-
ed on using the fast heating button
air conditioning controls. The duration is also
used to calculate the departure time for the
manual air conditioner. It can be set between
10 and 60 minutes at 10-minute intervals.
The programmed departure time determines
the approximate time it should take to reach
the temperature set in the vehicle. The start of
the heating operation is determined automat-
ically depending on the outside temperature.
Checking the programming
When a departure time is activated and the
ignition is switched off the control lamp of the
fast heating button
mately 10 seconds.
WARNING
Never programme the auxiliary heater so
that it switches itself on and is running in an
enclosed space or an area with no ventila-
tion. The auxiliary heater exhaust fumes
contain carbon monoxide, an odourless
and colourless toxic gas. Carbon monoxide
, Departure time
on the

lights up for approxi-

»
163