Seat Tarraco 2020 Owner's Manual page 320

Rear volume*
Volume in the rear area.
Rear sound settings/sharpness*
Sound tone in the rear area.
Adjust volume
When the parking aid is switched on, the vol-
ume of the audio source will be reduced, de-
pending on the selected option.
Error messages
If a an error or fault message appears on the
instrument panel in Parking assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
next time the parking aid is connected.
If a rear sensor is faulty, only the obstacles in
›››
area are displayed
A
sensor is faulty, only the obstacles in area
are displayed. Symbol

We recommend taking the vehicle to a speci-
alised workshop to have the fault repaired.
318
Trailer mode
Fig. 291
with trailer attached.
On vehicles with a factory-fitted trailer hitch,
when the trailer is connected, the rear sen-
sors will not activate when reverse gear is en-
gaged or button
objects behind or to the side of the vehicle
will not be indicated on the screen and no
audio signals will sound.
The screen will only display objects detected
Fig. 287. If a front
at the front, and the vehicle's trajectory will
B
be hidden.
is displayed.
Manoeuvre braking function*
3 Only valid with Parking System Plus
The emergency braking function is used to
minimise damage in the event of a collision.
Driving
Parking assist display on the screen
is pressed. Therefore, any

Depending on the equipment, if the Parking
Aid is active, the braking while manoeuvring
function activates emergency braking when it
detects an obstacle in the vehicle's path that
could cause a collision, driving forwards or in
reverse.
The function will not brake if the Parking Aid is
activated automatically. For the system to
operate, manoeuvring speed must be be-
tween 2.5 and 10 km/h (between 1.5 and 6
mph) for the front area and between 1.5 and
10 km/h (between 1 and 6 mph) for the rear.
Following an intervention, the braking while
manoeuvring function will be inactive in the
same direction of travel for 5 metres. Once
the gear is changed, or the selector lever's
position is changed, the function will be ac-
tive again. The Parking Aid's limitations apply.
The manoeuvre braking function is set in the
Easy Connect system with button
TINGS > Parking and manoeuvring
– permits the use of the braking while
● on

manoeuvring function.
– does not permit the use of the
● off

braking while manoeuvring function.
Temporary suppression of emergency
braking
When the function is deactivated with the
●
button that appears on
Manoeuvre braking
> SET-

.