Seat Tarraco 2020 Owner's Manual page 303

parking brake. Use the jump-start
›››
page 51.
When the electronic parking brake is ap-
●
plied or released, noises may be heard.
The system performs automatic and au-
●
dible tests sporadically in the parked vehi-
cle if some time elapses without the elec-
tronic parking brake being used.
Auto Hold Function
Related video
Fig. 279
In the lower part of the centre con-
Fig. 280
sole: Auto Hold function button.
Braking and parking
The control lamp on button
 
›››
Fig. 280 remains on while the Auto Hold
function is connected.
Once connected, the Auto Hold function as-
sists the driver in keeping the vehicle station-
ary at repeated intervals or for a certain peri-
od of time with the engine running, for exam-
ple, when going up a slope, when stopped at
traffic lights or in heavy traffic with intermit-
tent stops.
When connected, the Auto Hold function au-
tomatically prevents the vehicle from rolling
when stationary without pressing the brake
pedal.
After detecting that the vehicle is stationary
and the brake pedal has been released, the
Auto Hold function holds the vehicle. The driv-
er can lift their foot off the brake pedal.
When the driver touches the accelerator
pedal or accelerates slightly to continue driv-
ing, the Auto Hold function releases the brake.
The vehicle moves according to the slope of
the road.
If the vehicle is stationary and one of the con-
ditions required by the Auto Hold function is
impaired, it disconnects itself and the button's
›››
control light goes out Fig. 280. The elec-
tronic parking brake connects automatically,
if necessary, to park the vehicle safely
Conditions for keeping the vehicle station-
ary with the Auto Hold function
The driver door must be closed.
●
The driver's seat belt must be fastened.
●
The engine is running.
●
Switching the Auto Hold function on and
off
Pulse button
 
on the button goes out when the Auto Hold
function is switched off.
Automatically engaging and disengaging
the Auto Hold function
If the Auto Hold function was switched on with
the button before disconnecting
 
the ignition, the function will remain on after
the ignition is re-connected.
If the Auto Hold function was not switched on,
it will automatically remain off next time the
ignition is engaged.
The Auto Hold function connects automat-
ically if the following conditions are met
(all points must be met at the same time
›››
):
1. The vehicle is kept stationary with the
brake pedal on a flat surface or on a
›››
.
slope.
2. The engine rotates "correctly".
›››
. The control lamp
»
301