5.
Assemble the prop rod to the bracket of the seat
with the washer and hairpin
Figure 104
1. Washer
2. Bracket (seat)
6.
Plug the 2-socket connector of the machine wire
harness into the connector for the seat switch
until the connectors latch securely
Figure 105
1. 2-socket connector
(machine wire harness)
7.
Rotate the seat forward slightly, remove the prop
rod from the detent, rotate the seat down until
the seat latches securely.
(Figure
104).
g202001
3. Hairpin
4. Prop rod
(Figure
105).
g202003
2. Seat-switch connector
21
Completing the Installation
of the CL-55 Modem Kit
No Parts Required
Closing the Seats
Multi Pro 5800 Machines
Move the prop rods for the seats into the slots and
tilt the seats down.
22
Powering the GeoLink
Components
No Parts Required
Procedure
1.
Turn the ignition key to the R
/
(diesel) position.
PREHEAT
RUN
2.
Verify that the following components indicate
that each receives power:
•
Control console—displays graphics and text
(Figure
106).
•
Satellite receiver—the
illuminates
40
(gasoline) or
UN
Figure 106
indicator
PWR
(Figure
107).
g310669