Installing The Modem-Antenna Bracket - Toro GeoLink CL-55 Installation Instructions Manual

4. Remove the capscrew (5/16 x 1 inch) and
washer (5/16 inch) that secures the right, front
fender to the cross-member support
Figure 39
1. Clip nut (cross-member
support)
2. Washer (5/16 inch)
5. Remove the right, front fender from the machine.
6. Remove the 6 push-in fasteners and 5 washers
(9/16 x 1/2 inch) that secure the inner-fender
shroud to the right, upper and right, lower-frame
tubes (Figure 40).
Figure 40
1. Washer (9/16 x 1/2 inch)
2. Push-in fastener
7. Remove the inner-fender shroud from the
machine (Figure 40).
Note:
Retain the right, front fender, inner-fender
shroud, capscrews, washers, and undamaged
push-in fasteners for installation in
the Right Front Fender (page
Replace damaged push-in fasteners with Toro
Part No. 117-2382.
(Figure 39).
g323168
3. Capscrew (5/16 x 1 inch)
4. Right, front fender
g323162
3. Inner-fender shroud
19 Installing
37).
11
Installing the
Modem-Antenna Bracket
Parts needed for this procedure:
1 Modem antenna bracket.
Removing the RTK Bracket
1. Remove the antenna cable between the coaxial
connector of the navigation receiver and the
RTK-antenna
1. Coaxial connector
(navigation receiver)
2. Coaxial connector
2. Remove the RTK-antenna from the coaxial
coupler (Figure
3. Remove the coaxial coupler, lock washer, and
jam nut from the bracket
43).
Note:
Discard the antenna cable, RTK-antenna,
coaxial coupler, lock washer, and jam nut.
17
(Figure 41).
Figure 41
3. RTK-antenna
4. Antenna cable
41).
(Figure 42 or
g031877
Figure