Toro GeoLink CL-55 Installation Instructions Manual page 11

Figure 19
8. Remove the USB drive and install the USB port
cap.
Updating the AGI Firmware
1. On the setup screen, press the S
the GPS icon, and the R
20).
Figure 20
1. R icon (setup
ECEIVER
screen)
2. GPS icon (setup screen)
2. In the GPS receiver dialog box, press the
F U
IRMWARE PGRADE
3. In the firmware upgrade dialog box, press the
confirm icon (Figure
Figure 21
1. Confirm icon
4. In the warning dialog box, press the confirm icon
(Figure 22).
icon and
YSTEM
icon (Figure
ECEIVER
3. S icon (setup
YSTEM
screen)
4. F U icon
IRMWARE PGRADE
(GPS receiver dialog box)
icon (Figure 20).
21).
Important:
while the sprayer display applies the
firmware upgrade.
g323322
1. Confirm icon
Note:
On the home screen, a message displays
about upgrading the ASC firmware
Updating the ASC Firmware
1. Press the wrench icon in the ASC firmware
g323324
message to navigate directly to the ECU settings
screen in setup
1. Wrench icon
2. In the Firmware Version column for ECU 1, press
the current version (X.XX.XX) icon
g323323
11
Do not turn off machine power
Figure 22
(Figure
Figure 23
(Figure 24).
Figure 24
(Figure
g323325
23).
g323326
g323337
25).