Toro GeoLink CL-55 Installation Instructions Manual page 22

Figure 56
1. RJ45 port (sprayer display) 4. Port seal nut
2. Cap
3. RJ45 connector (labeled
- —modem data
X CONSOLE
harness)
3. Plug the RJ45 connector of the modem data
cable labeled -
X CONSOLE
the sprayer display
4. Assemble the port seal nut over the RJ45 port
of the sprayer display, and tighten the seal nut
(Figure 56).
5. Assemble compression nut over port seal nut,
and tighten the compression nut
5. Compression nut
into the RJ45 port of
(Figure 56).
(Figure 56).
Routing the Modem Data Harness
Multi Pro 1750 Machines
1. Route the modem data harness along the data
harness for the control console
g310206
1. Modem data harness
2. Shock-support tube
2. Route the modem data harness under the
shock-support tube of the machine
3. Route the modem data harness across the back
if the relays and down
1. Data harness (control
console)
4. Align the 4-pin connector labeled
-55 of the modem data harness near the 4
CL
connectors for the modem-antenna harness as
shown in
22
(Figure
Figure 57
3. Data harness (control
console)
(Figure 58).
Figure 58
2. Modem data harness
Figure 59.
57).
g315306
(Figure 57).
g315307
ETHERNET