Table of Contents
Advertisement
Assembling the Rear GeoLink
Harness, Navigation-Data and
Electrical Harness, and Modem
Power Harness to the Battery
Cables
Multi Pro 5800 Machines
1.
Route the positive terminal (red wire), negative
terminal (black wire), and fuses block (50 A) of
the rear wire harness up between the battery
box and the chassis of the machine
Figure 94
1. Positive battery cable
2. Hex nut
3. Negative battery cable
4. Negative-ring terminals
(black wire)—rear
GeoLink wire harness,
navigation-data and
electrical harness, and
modem power harness
2.
Route the positive terminal (red wire), negative
terminal (black wire), and 10 A fuse block of the
navigation-electrical harness up between the
battery box and the chassis of the machine.
3.
Route the ring terminals labeled
of the modem power harness up
GROUND
between the battery box and the chassis of the
machine.
4.
Remove the T-bolts and hex nuts from the
terminals of the positive and negative battery
cables
(Figure
94).
5.
Assemble a T-bolt through the positive terminal
(red wire) of the rear wire harness, the positive
terminal of the navigation-electrical harness,
modem power harness, and terminal of the
positive battery cable
(Figure
94).
g315081
5. T-bolt
6. Battery post (positive)
7. Positive-ring terminals
(black wire)—rear
GeoLink wire harness,
navigation-data and
electrical harness, and
modem power harness
8. Battery post (negative)
and
BATTERY
(Figure
94).
6.
Loosely secure the terminals and the T-bolt with
a hex nut
(Figure
7.
Assemble a T-bolt through the negative terminal
(black wire) of the rear wire harness, the
negative terminal of the navigation-electrical
harness, modem power harness, and terminal
of the negative battery cable
8.
Loosely secure the terminals and the T-bolt with
a hex nut
(Figure
Connecting the Battery
Multi Pro 5800 Machines
1.
Connect the positive (red) cable to the positive
(+) battery post, and tighten the nut; refer to
Figure 94
in
Assembling the Rear GeoLink
Harness, Navigation-Data and Electrical
Harness, and Modem Power Harness to the
Battery Cables (page
2.
Connect the negative (black) cable to the
negative (–) battery post, and tighten the
nut; refer to
Figure 94
Rear GeoLink Harness, Navigation-Data and
Electrical Harness, and Modem Power Harness
to the Battery Cables (page
3.
Slide the insulator boots over both battery posts.
4.
Install the battery cover and secure it with the
strap; refer to
Battery (page
36
94).
(Figure
94).
36).
in
Assembling the
36).
Figure 29
in
Disconnecting the
13).
94).
Advertisement
Table of Contents
