Toro GeoLink CL-55 Installation Instructions Manual page 38

2. Secure the inner-fender shroud to the frame
tubes (Figure 96) with the 6 push-in fasteners
and 5 washers (9/16 x 1/2 inch).
3. Align the right, front fender to the machine as
shown Figure 97, and align the holes in the
fender with the holes in the frame.
Figure 97
1. Clip nut (cross-member
support)
2. Washer (5/16 inch)
4. Secure right, front fender to the clip nut of the
cross-member support
capscrew (5/16 x 1 inch) and washer (5/16 inch).
5. Secure the right, front fender to the roll bar
mounting channel with 2 push-in fasteners
(Figure 98).
Figure 98
1. Push-in fastener
6. Align the hole in the right, front fender with the
hole in the platform floor
the fender to the floor with a capscrew (5/16 x
1 inch) and washer (5/16 inch).
g323164
3. Capscrew (5/16 x 1 inch)
4. Right, front fender
(Figure 97) with the
g323166
2. Right, front fender
(Figure 99), and secure
1. Capscrew (5/16 x 1 inch)
2. Washer (5/16 inch)
7. Align the hole in the bottom console cover to
the hole in the shock-support tube and the
hole in the end console cover to the hole in the
cross-member tube
1. Capscrew (5/16 x 1 inch)
2. Washer (5/16 inch)
8. Secure the covers to the tubes
with 2 capscrews (5/16 x 1 inch) and 2 washers
(5/16 inch).
38
Figure 99
3. Platform floor
4. Right, front fender
(Figure 100).
Figure 100
3. Console cover (bottom)
4. Console cover (end)
(Figure
g323165
g323163
100)