Toro GeoLink CL-55 Installation Instructions Manual page 9

Importing Inventory Data
1. Plug the USB storage device that you used in
Exporting Sprayer Display Inventory Item Data
(page 4) data into the USB port.
2. Press the I
NVENTORY
Figure 13
1. I M icon
NVENTORY ANAGER
3. At the bottom of the screen, press the I
D icon (Figure
ATA
4. In the import from USB dialog box, press the A
I I
NVENTORY TEMS
Figure 14
1. A I I
LL NVENTORY TEMS
5. When the sprayer-display completes the
exporting, the press the E
of the screen.
6. Remove the USB storage device from the USB
port.
7. Rotate the key switch of the machine to the O
position, and remove the key.
8. Skip to 8 Disconnecting the Battery (page
M icon (Figure
ANAGER
2. I D icon
MPORT ATA
13).
icon (Figure 14).
icon
icon at the bottom
JECT
6
3
Verifying the U-Boot
13).
Firmware Version
No Parts Required
Procedure
1. Rotate the ignition key to the R
P
REHEAT
2. Press the System Information (Toro) icon at the
top, left corner of the screen
g323340
MPORT
LL
1. System Information (Toro)
icon
2. Full-screen icon
3. In the system information mini-view window,
press the full-screen icon
4. In the system information window, look at the
U-B
OOT
Important:
display 1 of the following U-boot versions:
• 2013.10-weimx6-1.0.1
g323341
• 2013.10-weimx6-1.1.0
If the U-boot firmware version is not
2013.10-weimx6-1.0.1 or 2013.10-weimx6-1.1.0,
contact the Toro Technical Assistance Center for
instructions on updating the firmware.
FF
12).
9
/R (diesel) position.
UN
(Figure
Figure 15
3. U-B
OOT
information
4. System information
window
(Figure
V information (Figure
ERSION
The sprayer monitor must
(gasoline) or
UN
15).
g323482
V
ERSION
15).
15).