Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Description
No parts required
No parts required
No parts required
No parts required
X25 monitor kit (sold separately—Toro
part No. 41637)
No parts required
USB Drive (GeoLink X25 software
version 4.04.40 or higher—CL-55
CDMA Modem Kit)
No parts required
No parts required
No parts required
Modem antenna bracket.
Modem antenna—GeoLink precision
spray system kit (Model 41633 or Model
41634)
Cable ties—GeoLink precision spray
system kit (Model 41633 or Model
41634)
Modem data harness—300 cm (118
inches)—GeoLink precision spray
system kit (Model 41633 or Model
41634)
Cable ties—GeoLink precision spray
system kit (Model 41633 or Model
41634)
No parts required
Modem power harness—1850 mm
(72-7/8 inches)—GeoLink precision
spray system kit (Model 41633 or Model
41634)
Cable ties—GeoLink precision spray
system kit (Model 41633 or Model
41634)
Qty.
Get a current copy of the software guide
–
and quick start guide.
–
Prepare the machine.
Export the sprayer display inventory
–
item data.
–
Remove the X30 sprayer display.
1
Install the X25 monitor kit.
–
Verify the U-boot version.
1
Update the GeoLink software.
–
Disconnect the battery.
Remove the seat and the engine access
–
panel.
–
Removing the right, front fender.
1
Installing the modem-antenna bracket
1
Install the modem antenna to the
machine.
7
1
Route the modem data harness.
8
–
Remove the terminating resistor.
1
Install the modem power harness.
5
2
Use
Need help?
Do you have a question about the GeoLink CL-55 and is the answer not in the manual?